Troubleshooting

I can’t connect my device.

1.Make sure the Adrenaline has a proper ground connection and the red/white ignition wire is getting 12v.
2. Go into your device settings and search/connect to the iQuad via Wi-Fi or Bluetooth, with the app closed Then open the app once connected.

All of my parameters are reading 0.

1. Go into your device’s settings and ensure you are connected to the iQuad+.
2. If there is only one gauge in your layout and no other values are showing, you must drag and drop what parameters you would like to see. 
To access the parameter pallet, click on the carrot at the bottom of the gauge layout and then drag and drop desired parameters.
3. Check your Data Link connection on the truck. If it is not connected, or the truck’s wires have corroded the iQuad+ will not read most parameters.

 What vehicle selection do I choose?

If your Adrenaline was manufactured in 2017+ you most likely have V2 tuning and must select V2 Dodge 1998-2002.
If you would like the V2 update, but have older tuning, Quadzilla offers a “Test and Update” service available here.

 My power level bar is green.

1. You are in a warmup mode, turn this off in the settings menu.

What wire do I tap on my VP44?

Click here for a detailed video showing what wire to tap on the VP44.

 I can’t go up in power levels.

1. Double check that you are connected to the iQuad+.
2. Check your Data Link Connection to make sure it is secure.
3. Ensure your warmup mode setting is in the off position.

All my gauge cluster lights are on without the key in.

Was the truck jump started or had a battery charger hooked up while the Adrenaline module was connected?
If so the main processor has been damaged and will require a board replacement.
Unplug the Adrenaline module and contact us during business hours.

My Truck will not start with Adrenaline plugged in.

Unplug the Adrenaline module and plug your factory map sensor harness back into the map sensor.
Contact us during regular business hours.

 My truck is in limp mode and/or not reading boost correctly.

1. Inspect/clean all connections for the map sensor.
2. Plug your factory map sensor harness into the map sensor.
3. Replace the map sensor with a genuine Cummins sensor.

 For all other issues please contact us during our normal business hours.

801-872-5472  

Monday-Thursday: 8:00am-4:00pm
Closed for lunch 12:00-1:00PM MST
Friday-Sunday: Closed
Closed all major holidays.